microGranny 2 is a monophonic granular sampler.
It reads wav samples from microSD card and applies granular algorithms to them. You can also adjust start, end, sample rate (tuned or free run), crush and envelope (attack release).
MIDI Input allows external control of all parameters as well as transposition of the samples, or playing individual grains by different keys.
Are there any differences in software amongst Limited Editions?
Limited Edition Grannies were sold with different versions of software, as it was approaching its final version. Since the first version of MG2 came out, we have updated the software several times. The software gets better and better thanks to your feedback! (Big thanks! <3 ) Anyway, it is possible to update your Atmega microcontroller with the newest arduino software posted on our GitHub. Still, we know that not all of the current MG2 users own a programmer, or can handle the update on their own. So you can get the preprogrammed chip with newest firmware HERE.
monophonic mono sampler
microSD card (storing + recording samples, storing presets)
6 sounds with full adjustments storable in a preset at once
60 presets in 10 banks (6 preset per bank), stored as .txt files on microSD card
wav sample playback from microSD card (mono, 22050 Hz, 8 or 16 bit, two letter file name)
8-bit 22050Hz wav recording via line input or onboard microphone
sample rate (tuned or free run)
start, end position with repeat, instant loop
granular settings: grain size and shift speed (positive or negative)
amplitude envelope attack and release
MIDI Input – responds to note, cc and clock (synchronize loop and grains)
MIDI side chain envelope restart
input & output volume knob
power switch – plug / battery
hackable – arduino based